You are currently viewing How To Install Sharkbite Fittings On Existing Copper Pipe

How To Install Sharkbite Fittings On Existing Copper Pipe

How To Install Sharkbite Fittings On Existing Copper Pipe. When installing sharkbite fittings always measure and mark any copper pipe that the sharkbite fitting will be sliding onto. Using a rotary tube cutter, cut the pipe so that the ends are square and flush.

Plumbing With PEX Tubing Family Handyman
Plumbing With PEX Tubing Family Handyman from www.familyhandyman.com

For installation, simply slide the sharkbite onto the end of the copper pipe and tighten the clamp using the provided wrench. The installation of sharkbite fitting into the copper pipe itself is not a difficult task to do however, the hard part appears when you have to do all the measurement work and select the correct fitting according to the size of your pipe. You need to insert the pipe through the release collar allowing it to sit against the grab ring.

Sharkbites Are Designed To Be Used With Copper Piping.

Pull the fitting to remove it from the pipe. Cut the copper pipe such that the ends are clear and sharp. To get started, identify the pipe material.

Place The Fitting Side Above The Barrel Of The Sharkbite Fitting.

Pipe insertion depth chart sharkbite fitting size nominal pipe size pipe insertion depth in 12 in. Squeeze the handle to compress the release collar, which is what makes the fitting let go of the pipe. The pipe was not squarely cut.

To Make Your Connection, Cut The Pipe As Cleanly And Squarely As Possible.

Position the pipe side prong so it's fully seated on the pipe. Insert the pipe into the sharkbite fitting. You need to insert the pipe through the release collar allowing it to sit against the grab ring.

Avoid Jagged Ends With Burrs.

The pipe was not properly inserted. Be sure the pipe is free of scratches or debris and cut the pipe as cleanly and squarely as possible. When pipe is not fully inserted, it will leave room for leakage.

Replacing Copper Pipes And Fittings With Sharkbite Push Fit Connectors Is Super Easy.

Use your sharkbite deburr & gauge tool to measure and mark the insertion depth on your pipe.make the connection. Cut pipe cleanly & squarely. Ensure the pipe is free of scratches and debris.

Leave a Reply