How To Light Pilot On Heatilator Gas Fireplace. Push in the pilot knob, which manually sends gas into the system. Here’s how to light a gas fireplace with a control panel.
A gas fireplace would need to be converted to a wood burning fireplace or stove to burn wood. Locate pilot assembly with spark igniter (located behind and below logs in the firebox. Turn the knob from the “off” to the “pilot” position.
Turn The Knob From The “Off” To The “Pilot” Position.
Depending on how long it's been since the gas fireplace was. A gas fireplace would need to be converted to a wood burning fireplace or stove to burn wood. You can adjust the flame height by turning the gas key.
Turn On The Supply Line To The Gas Fireplace.
How to light gas logs in fireplace? Check the air draft of the vent cap. Turn the knob from the “off” to the “pilot” position.
While Installing A New Vent Cap For The Gas Fireplace, Make Sure To Attach A Draft Stopper To Get Rid Of The Problem Again.
To light gas logs safely, turn the control handle to the pilot position, press it in, light the pilot with a match and hold down the handle for. Pull the match or light away when the burner lights. Locate the control knob, push it in, and rotate so “pilot” is at the hash mark.
Continue Pushing In On The Knob For About 30 Seconds To Ensure It Stays Lit.
Evacuate the air and try lighting the pilot light. While still pushing on the knob, press the igniter several times until it fires. To light burner, turn knob counter clockwise t.
If The Fireplace’s Ignitor Still Doesn’t Ignite, Replace The Vent Cap.
Turn the knob from the “off” to the “pilot” position. Depending on how long it’s been since the gas fireplace was last used, ignition may take several attempts before igniting. If it doesn’t light, wait five minutes and retry.